Steam Jet Mill for PC Sheet This product technology has been widely valued by the industry. Steam Jet Mill for PC Sheet is mainly used to determine its wide range of applications, high fine, typical materials: super hard diamond, silicon carbide, metal powder, high purity requirements: ceramic pigment, medicine, biochemistry, medicine . Steam Jet Mill for PC Sheet converts the normal gas source from the gas source portion to nitrogen, carbon dioxide, etc., is an inert gas protection device for use in flammable and explosive, oxidized materials, combination, grading, and processing.
In terms of airflow milling, it is important to understand its operational rules, which is very important because only familiarize the procedure, can operate correctly.
First, the operation rules of Steam Jet Mill for PC Sheet are as follows: After the preparation before the boot receives the production order, the material is prepared. Complete the site to clean the grocery. Check whether the transportation pipes and auxiliary equipment, whether the pipelines are blocked, leak or poor sealing, whether the auxiliary equipment is intact, whether it works normally. Whether there is a phenomenon that the material is accumulated in the outer casing and the separator, if the accumulated material is required. Whether the bearing is lubricated, whether it is lubricated in an appropriate place. Check if all pipes, fastening bolts, washers, spindles, and instruments are intact, normal and flexible.
Second, the Start of the Steam Jet Mill for PC Sheet First start the motor, control the current and time at starting, so that the device can start running. When the equipment is operating normally, the feed speed can be adjusted according to the properties of the material. Uniform continuous feed should not be large or small, thereby affecting the separation effect of the grinding machine, making the machine easily malfunction. During operation, if an abnormality occurs, stop checking immediately before the failure continues.
Third, the main procedures for the close and inspection of Steam Jet Mill for PC Sheet are as follows: After the material in the grinding machine housing is completely pulverized, it should stop the feed and turn off the motor. After the machine is idling for 3 minutes, press the stop button to stop the machine. When the machine is completely stopped, open the check door and check the wear of the vessel. Fill in the corresponding production record, update the device status flag, which is convenient for the next use.
Characteristics of Steam Jet Mill for PC Sheet:
1. The mill is large, the energy consumption is low, and the grading efficiency is high.
3, the structure is reasonable, the pulverizer can produce 1-6 kinds of products at the same time according to user requirements.
4, the applicability is strong: the pulverizer can be combined with all kinds of Mills (air compressors, mechanical ball mills, ball mills, Raymond grinders, vibrating mills, etc.) to form closed or open joint operations.
5, the degree of automation is high:
During the daily maintenance of the Steam Jet Mill for PC Sheet
1, during the production process, the temperature rise of the bearing must be checked, when the temperature rise exceeds 50 ° C Attention should be stopped, and the reason is to rule out the fault.
2, when the new machine is running, the drive belt is easy to elongate, and should pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt.
3, if the loss case should be checked frequently, replace the quality and production volume in time.
4, the blade, the bushing should often check the wear situation. If the wear is worn, the productivity is lowered, and the particle size is replaced after the particle size is replaced.
5, the host and the graded flow bearing are lipids, and the No. 2 special lipids are used 265-295.
7. The spiral feeder has been changed during the change of the lipid of 4,000 hours, and the calcium-based grease is added.
ALPA Raw Powder Steam Jet Mill for PC Sheet Case Sharing:
A mechanical equipment company, the company mainly produces pharmaceutical equipment and powder automation equipment, and acts in the United States and Germany imported equipment The company has the advantages of technology and the team's cohesiveness has achieved rapid development and broke the monopoly of foreign equipment in the industry.
Case parameters:
Product particle size: D90: 2-80UM
Human Yield: 50-80kg
