Jet Mill of Wax Powder As the name referway is a mechanical equipment applied to the production area, which is mostly used in pulverizing granules, fast pulverity, good precision.
Many manufacturers who want to make a crushing process Will choose to buy a Jet Mill of Wax Powder, but not all the crushers can apply to production and processing, and the wrong processing method will make the pulverizer wear speed. The mill is wear is too fast, and the inner cavity of the pulverizer of the material should be selected when the material hardness is too large. The equipment operates for a long time in a higher crushing pressure, which requires a periodic replacement loss for uniformity. The products after crushing are generally single peaks, and if there is a double-peak or peak, there is a unstable pressure. The solution is based on the gas supply of the gas source equipment to meet the amount of gas required for work, ensuring that the lowest air supply pressure of the gas is high than the working pressure. The feed speed is unstable. Solution to check if there is a blockage at the feed valve; the material is not very viscous, uniform liquidity, and the stable control feed speed. A filter cake is formed in the pulverizer chamber. The solution is suspended, and the filter cakes in the crushed chamber will then return to the production.
Let's take a look at how to extend Jet Mill of Wax Powder:
1, strictly follow the operating procedures;
2, easy to damage parts should pay attention to time check, replace it in time .
3, the device body has no rotating parts, which is not affected by the lifetime of the bearing. However, due to the difference in powder hardness, the degree of wear is different, especially the wear of the hierarchy knife tip, our company's body part is made of special material, the tip service life is at least more than one year, the knife tip is more than 1 cm or more It will affect the grading accuracy, in order to avoid affecting product quality, it is recommended to contact us to replace the knife pointer;
4. It is recommended to use a long filter device to improve equipment stability, and ensure grading precision.
The smaller the particle size of the raw material, the higher the pulverization efficiency, the greater the particle size of the raw material, then the pulverization effect is relatively low. In the case of crushing pressure and feed pressure, reduce the feed speed product will be finer, and improve the feed speed product will become thick. In the case of a feed rate, the particle size of the pulverized pressure is improved, and the pulverization pressure is reduced, and the product will become thick.
So the particle size control is the adjustment of the parameters during the pulverizer to achieve different pulverized fineness, and it is necessary to measure the relationship between the feed velocity and pressure before crushing and then determine the appropriate pulverization parameters.
Technical parameters:
Finished particle size: lithium cobaltate small particles D50: 3-6 μm; lithium cobaltate large particles: 50: 8-20 μm; Trimetimeterials D50: 6-13μm;
Production capacity:Lithium cobaltate small particles: 250kg of cobalt acid lithium large particles: 500KG ternary: 500kg
