RTM Turbo Mill Maintenance and Repair

The following is Shandong AlPa Powder Technology Co., Ltd. shares the contents of the RTM Turbo Mill maintenance and repair. 

1. Safety procedure
 A. The mixer drive chain protective cover should be in good condition to prevent personnel from contacting the work chain and cause personal injury accidents. 
B. Taster bolts of the motor base should be checked regularly. The base should have sufficient stiffness to prevent the chain from jumping or fallen due to the basis, resulting in failure. 
C. When checking, repairing and maintaining the machine, the power must be cut off and the sign must be suspended. 
D. It is strictly forbidden to put your hand or other tools in the machine during the machine. 
E. You can clean and check the machine only after the machine is completely stopped. 
F. Cables and wires should have a protective housing. 

2. Maintenance procedures a. During operation, each class checks at least once, and discharging a water in the three joint interface in the oil water. B. Check if the unloading door leaks once a week, the sealing strip is damaged, and whether the unloading link mechanism is in a dead point when the door is closed. C. Clean a residual substance attached to the inner wall of the buffle over a week. D. Brush the conveyor chain and sprockets per month, and brush the oil onto the sprocket. E. Clean a nozzle per month while cleaning the remaining materials on the inner wall of the mixer and the cover. F. Monthly determination of a mixer exit and finished package ports. The variation coefficient should be determined by selecting the shortest mixed product. 

3. Maintenance Program Small repair mixer is carried out every six months, including the following content 
A. Check if the wire connection in the motor junction box is loose. 
B. Clean the residue of the inner wall of the mixer and buffer. 
C. Clean oil water separation three pieces to ensure smooth flow. 
D. Check the wear situation of each hinge pin of the unloading link mechanism, replace the pin, and ensure the reliability and stability of the link mechanism. 
E. Replace the unloading door seal, check the reliability of the switch gate limit position, and adjust its position to ensure unloading door seals. 
F. Check the tightness of the conveyor chain, tighten the motor space, adjust the chain tensioner or motor base to keep the chain's correct tension. 
G. Replace the gear reducer grease. 

The medium repair mixer is repaired once a year, including the following contents. 

A. Clean the rotor wear and rotorThe gap between the object, repairs or replaces the wear belt or blade, and adjusts the gap between the rotor and the housing to the allowable range (about 5 mm). 
B. Clean the main bearing and bearing housing, check the wear situation, if necessary, and inject the lubricating oil within the bearing. 
C. Check the wear of the cylinder and replace the part of the severe wear. 
D. Check the compressed air line, especially the aging of the hose, and replace it if necessary. 
E. Remove and clean the reducer, check the wear situation of each component, and replace the wear parts if necessary, and add grease to the gear. 
F. Check the wear situation of the transmission chain and the sprocket, and replace it if necessary. 
G. Check the wear of the motor bearing and add grease to the motor bearing. 

The above is RTM Turbo Mill Maintenance and Repair, please pay attention to Shandong Alpa Powder Technology Co., Ltd., the company mainly has Jet Mill, airflow, pharmaceutical Jet Mill, disc Jet Mill, RTM Turbo Mill.