Xiaobian sorted out the contents of the fault caused by the improper operation of the operational pharmaceutical Jet Mill, and the pharmaceutical Jet Mill has gradually penetrated into people's daily lives with the continuous development of pharmaceutical Jet Mill technology.
The clogging of the pulverizer is the most common fault of mechanical design, which may be one of the most common faults in mechanical design, but there is more faults caused by improper operation.
The feed speed is too fast, the load is increased, causing clogging.
During the breeding process, pay attention to the current instrument pointer's deflection angle. If the rated current is exceeded, the motor is overloaded, long-term overload, will burn the motor. This situation should be reduced or closed immediately, but also change the feeding mode, by increasing the amount of feed to control the feed rate. Because the energy rolling mill is fast, the load is large, and the load fluctuates.
Therefore, the rolling mill is generally controlled around 85% in the rated current.
(1) The entrance of the discharge tube is too bad or the interference is too fast, and the export of universal crusher is blocked; the mismatch of the conveying equipment can cause the drainage to clogging the weaken or calm. To find out the fault, we must first clarify the export transport equipment, do not change, adjust the amount of feed, so that the equipment is running normally.
(2) The hydraulic content, aging, screening, crushing and sealing materials are too high, which will cause universal grinding.
The hammer mill should be updated regularly, which is seriously aging, and regularly check the screening surface, which increases production efficiency, and universally grinding the machine without blocking, grinding to improve reliability.
Shandong AlPa Powder Technology Co., Ltd. is committed to medical Jet Mill, has a mature process process, strong technical force, professional engageful Jet Mill, survive with quality, welcome everyone to come to consult.
