1. Materials are not adjusted from the refrigerated air door of the feed port, the material output pipe is blocked, the screen is blocked, the collecting bag is too short or the gas permeability abrasion, and the hammer has a serious wear, which will cause this phenomenon. In this case, the reason should first be checked, and then the tunnel is cleared, or the combiner, or the hammer, or the change of the hammer, or the change of the hammer. 2. Bearing rises hot when the bearing lubrication is poor, damaged or spindle bending, the rotor is severely imbalance, and the belt is in tightening. The bearing condition can be restored to normal by replacing the bearing, spindle, addition, replacement of lubricants, balance the rotor, adjustment of belt looseness.
3. Crusher's strong vibration The following reasons may result in strong vibration of pulverizer:
1 Hammer installation is incorrect;
2 The weight deviation of the corresponding two sets of hammers is large;
3 bearing damage or spindle bending; 4 foot stops fixed Screw loose. If the hammer is arranged, it should be re-arranged in accordance with the requirements of the specification; if the weight deviation of the two sets of hammers should be balanced, the weight should not exceed 5 grams; if the bearing is damaged or the spindle is bent, it takes timely Replace; if the underlying connection screw is loose, it should be fastened.
4. There is a vocalization in the pulverizer. The parts are damaged, fall off, or have a stone, including a stone, iron block, etc., it will generate a vocalization, at which point it is necessary to stop checking, replacing damaged parts or will Hard taken out.
5. The reason for the low production efficiency causes the reason for the fact that there is insufficient motor power, and the belt wheel is formulated, the belt slip is slippery, the hammer is severely worn, and the amount of water contains unevenness or the water content in the feed is too high. In the above, the corresponding measures can be resolved in response to the corresponding measures, replace the motor or belt wheel to increase the speed, but cannot exceed the rated working speed; adjust the belt looseness, replace the belt, or replace the hammer.
When the operation is uniform, a small amount is added, maintain continuous and uniform; the wet raw material should be dried and then pulverized.
Shandong AlPa Powder Technology Co., Ltd. is a scientific and technological private enterprise specializing in the development, manufacturing, and application of various Jet Mill series.
