The bearing is a very important part of the pulverizer. If the axis is in the problem, it will directly affect the normal operation and operation efficiency of the pulverizer, then one of the Jet Mill manufacturers, one of the shandong alpa Powder Technology Co., Ltd. Talk to everyone if the bearing of Jet Mill has failed, what to do?
(1) The two bearing hoses are low, or the motor rotor and the pulverizer rotor are different from the rotor, which will cause the shaft to an additional load, thereby causing the bearing overheating. This happens, there is a stop to troubleshoot the fault immediately to avoid early damage of the bearing.
(2) Excessive lubricants in the bearing, too little or aging is also the main reason for the damage of the bearing overheating, so, according to the use of the book request, the lubricating oil is quantified, generally lubricated 70% of the bearing space - 80%, too much or too little is not conducive to bearing lubrication and heat transfer. Bearings extend its life.
(3) The bonding cover and the shaft are too tight, and the bonding and axis of the bearing is too tight or too loose. One, this problem occurs, in the operation of the pulverizer equipment, the sound of friction and obvious swing will occur.
Remove the bearing should be downtime. Trim the wear area and re-assemble it as required.
The above is one of the shredder manufacturers, SHANDON ALPA POWDER TECHNOLOGY Co., Ltd., if the shredder is faulty, what to do, more about crusher consulting, please continue to pay attention to the ALPA powder official website!
