In the process of Jet Mill, device failure may occur, in general, we can overhaul Jet Mill themselves!
Here is one of the Shandong Alpa Powder Technology Co., Ltd., Shandong Jet Mill supplier!
First check the power outlet, plug, power cord, no oxygen off, break, if you do not have a power test machine, when the motor is powered, it can be turned to rotate, it can be determined that it is There is a capacity failure in the two starting capacitors of the aircraft.
In this case, there is generally only new products.
Another situation is that the power is not rotated, and the external force can be rotated, but a weak current sound is issued in the motor, which is caused by mild leakage of the activation capacitor. If the current is too large, the motor does not start at all, and it is determined to start the capacitor short circuit (the motor coil short circuit requires professional repair).
In the absence of professional instruments, the capacitance can be removed first, and the two leads are inserted into the zero and fire tunnel of the mains, and then the two lead short circuit is discharged. If you can make a discharge spark and a sound of "" sound, this capacitor can be used; if the sparks and sound are weak, the capacity of the capacitance has decreased, and the new or add a small capacitor. If the capacitor has been damaged, it cannot be used, and it must be replaced with new products with the same size.
There is another type of small high-speed pulverizer. This crusher is generally very good, and daily maintenance is more important. The following is the maintenance focus of this type of crusher.
Check if the lubrication of the bearing is good to check if all fasteners are tight.
Check if the drive belt is installed correctly and the situation is good. If the belt breakage should be replaced in time, when there is oil in the belt or the groove, apply a clean rag to clean.
Check if the protective device is good, if it is found that the protective device is unsafe phenomenon, it should be excluded in time.
Check that there is an ignorant or other debris in the damage chamber, if it is sometimes cleaned.
Check if the hydraulic top machine head or the starting roof rod is returned, adjust whether the gasket is properly installed correctly and compact.
Of course, when the faults of Jet Mill are more complicated, they should also contact professional maintenance personnel to view. About the above related content of Jet Mill, etc.Powder Technology Co., Ltd. is available!
