We know that Jet Mill is very much, different types of Jet Mill uses are different, how to correctly choose to make a problem for each Jet Mill, one of the Jet Mill manufacturers, one of Shandong Alpa Powder Technology Co. , Ltd. To introduce you!
1. When selecting, first consider the purchased Jet Mill is the raw material for crushing. The pulverized cereal feed is mainly, select the top feeding hammer pulverizer; the crushed crumpled bran, the wheat feed, can choose the claw pulverizer; if it is required to be very versatile, if it is dominated by pulverized cereals, Take care of the pie valley and straw, select the tangential feed hammer slurry; mineral feed such as crushing shell, can be used as a seashell-free sutching machine; if used as pre-mixed feed, the granularity of the product is required. The fine can be adjusted according to the needs, and the special non-singulated pulverizer should be used.
2. General Jet Mill's instructions and nameplates, there is a rated production capacity (Kg / h) of the pulverizer. However, attention should be aware of:
(1) The rated production capacity is usually based on the state of pulverizing the corn, the water content of the water storage safety water (about 13%) and φ1.2mm aperture screen, because corn is Commonly used cereal feeds, screens of 1.2mm aperture are commonly used minimum sieves, at which point production capacity is small, which considers more common and difficult states in production.
(2) The production capacity of the selected pulverizer is slightly larger than the actual production capacity, avoiding the production capacity of hammer wear, air-stop wind, etc., does not affect the continuous production supply of feeds.
3. The energy consumption of Jet Mill is very large. When purchasing, energy saving is not considered. According to the standards of the relevant departments, the hammer pulverizer is not less than 48 kg per degree of electricity at a sieve of φ1.2 mm sieves with φ1.2 mm sieves.
4, Jet Mill's supporting power. The power kWh of the pulverizer is loaded on the machine manual and the nameplate. It tends to indicate that is not a fixed number but has a certain range.
5. Jet Mill mitigation should be considered. The pulverized finished product has three modes: self-weight falling, negative pressure suction and mechanical delivery.
Small stand-alone uses self-weight delivery mode to simplify the structure. Most of the medium pulverizer has a negative pressure suction device.The advantage is that the moisture of the finished product can be taken away, reducing the humidity in the finished product facilitates storage, increases the pulverization efficiency 10? 15%, and lower the dust level of the pulverizer. The agency is delivered to a crusher that is more than 2.5T is used.
6, Jet Mill of dust and noise. Dust and noise in feed processing are mainly from the pulverizer. These two sanitation indicators should be fully considered when selecting. If there is noise and a crusher of noise and dust should be tested and dustproof measures to improve the working environment, which is beneficial to the health of the operator.
The above related content of the Jet Mill models such as how to correctly choose the Shandong AlPa Powder Technology Co., Ltd., one of Shandong Jet Mill manufacturer!
