In the above article, one of the Jet Mill suppliers of Shandong AlPa Powder Technology Co., Ltd. introduced how to use the crushing machine correctly?
What is the need for our attention and other related content, today Xiaobian will then introduce you to what kind of way we need to repair maintenance and the method of troubleshooting the pulverization machine when we use the crusher.
First, the maintenance of the crusher
1. During the production process, the temperature rise of the bearing must be often checked. When the temperature rise exceeds 50 ° C, it should be stopped, and the reason is to rule out the fault.
2, when the new machine is running, the drive belt is easy to elongate, and should pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt.
3. If the loss case should be checked frequently, replace the quality and production volume in time.
4, blade, the bushing should often check the wear situation, if wear, the productivity decreases, and the particle size is replaced after the particle size is replaced.
5, the host and the grading flow bearing are lipid lubrication, using 2 special lipids, degrees 265-295.
6, the replacement period of the bearing is 2000 hours, the amount of the grease is filled with 1/2 (epithelial) or 3/4 (lower test) of the space in the bearing cavity, or the 3/4 (lower test) is not too much to fill the grease. Otherwise, the bearing temperature can cause the bearing temperature. Too high.
7, the spiral feeder has changed the lipid period of 4,000 hours, and the calcium-based grease is added.
Second, the pulverizer troubleshoot
1, in the output shaft E, ie the pulley E, avoiding the heavy hammer slamming, damage the part.
2. It is strictly forbidden to turn the handle on the stop.
3, the lubricating oil used in this regulator, using N32 alkaline high-zinc high-grade anti-motor hydraulic oil, deceleration machine 401 generally lubricating oil, and eliminates other oil alternatives.
4, after 3000 hours, the new oil should be replaced, then the second change after 500 hours, and then use 1000 hours to change once.
The above is what kind of way we need to take care of the maintenance, and the Shandong AlPa Powder Technology Co., Ltd., one of Shandong Jet Mill manufacturers!
