When using Jet Mill, first connect the airflow compressor, filter, and grinding machines using an oxygen pipe and a connector, it is best to perform sound insulation processing on the airflow compressor, so that the environment and personnel will not be used during operation. There is too much pollution.
Ceramic liner pipes are manufactured by high-tech production processes - self-provisional high temperature clutch synthesis method. The tube consists of three layers of corundum ceramics, transition layer, and steel from the inner to the outside, and the ceramic layer is formed in a high temperature of 2,200 ° C (Al2O3) to form a strong bond through the transition layer with the steel pipe. Check if the connections of each part of the Jet Mill are fastened, whether the screws on the ground are installed normally, all of which should be adjusted. After the installation is complete, open the air compressor, the feeder does not need to open and carefully check the airflow channel. Make sure that the three valves and pressure gauges are working properly, the pipeline system does not leak water, the collection box and the exhaust system are normal, turn off the airflow compressor to open the feed equipment, and then try again.
The above operation is normal and started slowly on the device. Flat airflow mill is simple, easy to manufacture due to flat air flow milling, easy to manufacture, so it is widely used.
Structure: Mainly composed of a crushing chamber, a nozzle port, a discharge opening, a gas flow outlet, a compressed air inlet, a grading area, and the like.
Working principle: Transform the compressed air or overheating steam into a high-speed airflow through the nozzle, when the material is sent to the pulverizing chamber by the feeder, a strong impact and dramatic friction make the material are pulverized Become a super fine product. Open a small number of values and feed devices first, and produce a small part of the material. The feeder cannot be sent once. Need to slowly put into automation equipment, in the production process, the related valve and pressure gauge should be noted, find that the Jet Mill misoperation needs to stop the device immediately, and then solve the problem after carefully detecting.
