Jet Mill's working principle is composed of a cyclone separator, a dust collector and a fan.
The whole ceramic Impact Mill is a comprehensive domestic and international similar crusher technology, and there is an advantage of impact breaking and hammer. New fine breaks, coarse mills, which optimize the design and development of major technical parameters, have the characteristics of breaking the crushing ratio, smooth energy consumption, simple structure, convenient operation and maintenance. It is a real multi-purpose, high efficiency, low-cost new crushing equipment. Under the action of fan pump, the material high speed moves from the lower end entrance of the grading machine to the hierarchical region.
The coarse material is separated from the fine material under the action of high-speed rotary grading machine. The fine particles that satisfy the particle size are entered into the cyclone separator or dust collector by the gap of the graded wheel blade, and the speed of the crude particles retains after the hit wall, and then falls along the wall of the secondary air, and is quenched by the secondary airflow Strong washing effect washed away. The crude particles were separated, and the fine particles increased to the secondary partition, and the crude particles were reduced to the discharge port.
Characteristics of the classification machine: Suitable for fine grading of dry micron products. Flat airflow mill is simple, easy to manufacture due to flat air flow milling, easy to manufacture,
so it is widely used. Structure:
Mainly composed of a crushing chamber, a nozzle port, an air outlet, a gas flow outlet, a compressed air inlet, a grading area, and the like. Working principle: Transform the compressed air or overheating steam into a high-speed airflow through the nozzle, when the material is fed into the pulverizing chamber by the feeder, a strong impact and dramatic friction make the material into a super fine product.
It can be used for the classification of spheres, sheet-like and needle particles, can also be used for particles of different densities. The granularity of the grading machine can reach D97: 2U 150 microns, and the product particle size is unmatched, and varieties are extremely convenient. Hierarchical efficiency (extraction rate) 60/90, high grading efficiency, and vice versa. The vertical grading turbine, low speed, good wear resistance, and low system power configuration.
Multi-level classifier can be used in series while producing a plurality of particle size sections. It can be used in series with a ball mill, a vibrating mill, a Raymond mill, and form a closed circuit cycle.
The control system uses program control, and the operating state is displayed in real time, and the operation is simple. System negative pressure operation, dust emissions are less than 40 mg / m3, and the device noise is not higher than 75 dB (a) by using an muffler measures.
