Today, I talk about the operation of Jet Mill, to introduce the pulverizer equipment manufacturers talk about Jet Mill's operation Fluidized Bed Jet Mill, although the name is very long. But in general, it is also a Jet Mill, so it is within the scope of our study.
So since it mentioned it, let's take this instructions in this regard, explain some basic content so that everyone can understand and understand this Jet Mill, increasing our knowledge in this area.
1. Preparation before booting
(1) Check the host, accompaniment, pipeline, and valve, whether it is intact, is there any problem.
(2) The frequency and bandwidth of the pulse controller is preferably provided, and the filter bag should be ensured.
2. Power on
(1) Turn on the air compressor and freeze the dryer to check that the cooling water can flow normally.
(2) The compressor should operate in accordance with the requirements.
(3) When the freeze dryer is turned on, its pressure value must meet the requirements of the specified requirements.
(4) First turn off the wind turbine regulating valve, then open the air machine, and then gradually open the winding valve until the required air volume.
(5) Open the main gas valve, when the pulverizer reaches 0.8 MPa, turn on the trap counter-blowing valve to reach 0.4-0.6MPa, then turn on the cyclone separator and trap valve.
(6) To control the amount of addition, too much or too little.
3. Stopping
(1) Stop the feeding, then turn off the main gas valve, stop the compressor, and then turn off the air in the air to enter the air valve, stop the fan.
(2) Stop the motor, turn off the cleaning valve and sealing valve.
(3) After the end of the stop, you can turn off the control box.
Welcome to Shandong Alpa Powder Technology Co., Ltd., the above about pulverizer equipment manufacturers talk about Jet Mill.
