DISC Jet Mill OF Steel SLAG can be used for important or need to be grounded to granular product processing, the ALPA ultrafine pulverizer product is good, affordable, factory direct sales, also to promote after-sales maintenance service for customers, service attitude
DISC Jet Mill OF Steel SLAG is suitable for combating machinery of materials such as synthetic resins, food, chemicals. The apparatus is different from the ordinary inner grinding machine, not only simply crushed, such as impact force and cutting force, but also by many generated ultrasonic eddy currents and vibration thus generated high-frequency pressure vibration to crush the material. Under certain conditions, the viscous material and the elastic material can also be pulverized. The pulverizer is almost no increase in the cyclic temperature during the pulverization process, so the thermal material can also be pulverized. The pulverizer has a reasonable structure, stable operation, low energy consumption, large crushing capacity, small size, no fault, easy to clean and maintenance. General shells use water cooling and their own air volume, conveying crushing materials, improves temperature, and reduces thermal materials. The wear of the blade is caused by a large amount of ultrasonic vortex generated by the back of the blade and the vibration of the high frequency pressure. Compact, no dust, no dust.
DISC JET MILL OF Steel SLAG Operation Performance: In the cyclone dust collector, the bag type dust collector is auxiliary, the host is set in the centrifugal grading device, which can be fine grind, and has a classification function, the wind is cut, no Sieves or mesh, powder particles can be adjusted arbitrarily, after crushing materials, negative pressure delivery to the exhaust valve port, reach the product requirements, super fine classifier is widely used in chemical, dyes, coatings, pharmaceuticals, food and other industries.
DISC JET MILL OF Steel Slag's daily maintenance
1, during production, the temperature rise of the bearing must be checked frequently, when the temperature rise exceeds 50 ° C, should be closed, and the reason is to exclude Fault.
2, when the new machine is running, the drive belt is easy to elongate, and should pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt.
3, if the loss case should be checked frequently, replace the quality and production volume in time.
4, the blade, the bushing should often check the wear situation. If the wear is worn, the productivity is lowered, and the particle size is replaced after the particle size is replaced.
5, the host and the graded flow bearing are lipids, and the No. 2 special lipids are used 265-295.
6, the replacement period of the bearing is 2000 hours, and the amount of the grease is filling the amount of the space in the bearing cavity (episode) or 3/4 (lower test) cut, not too much to fill the grease, otherwise The bearing temperature is too high.
7. The spiral feeder has been changed during the change of the lipid of 4,000 hours, and the calcium-based grease is added.
Technical parameters:
Finished particle size: 200 mesh 90% passed
Production capacity: 4-5T
