Today's industrial requirements have significantly improved, and thinner powder is conducive to the deep processing of the product, thus makes the product more value. Jet Mill for Tungsten Powder can effectively improve the level of massage of materials and greatly improve productivity. Jet Mill for Tungsten Powder has received attention, and the prospect has also been optimistic about many people.
The variety of Jet Mill for Tungsten Powder is now very large, and its grading quality and level are also very large. In general, the evaluation of grade grading performance is expressed in grading efficiency and grading accuracy. But the current level of grading efficiency and grading accuracy have many inconveniences in practical applications. Through the analysis of the classification efficiency of the collected evaluation grade performance and the level of grading accuracy.
Next, we understand the working principle of the ultrafine pulverizer.
When working, the material to be pulverized from the feed hood on the side of the hood shell, relying on the grinding roller device suspended on the main plum flower frame, rotating around the vertical axis, and itself is rotated, due to rotation The role of the grinding roller is swing outward, pressing the mill, so that the shovel shovel is sent between the mill and the abrasive ring, and the purpose of the pulverized material is achieved due to rolling rolling of the grinding roller. Warlective process: After the material is ground, the fan blows the wind into the main casing, blows the powder, and is selected from the analyzer above the grinding chamber, and the fine material is refined into the grinding chamber. The style of constructing the wind flow into the cyclone collector, and after collecting the powder, it is the finished product.
The wind flow is reflected in the wind turbine in the upper end of the large cyclone collector, and the wind path is cycle, and in the negative pressure state, the air of the circulating wind turbine increases the exhaust gas pipeline between the flowers and the middle of the main unit. Small cyclone collector for purification treatment.
1. If a lubricating oil is added to the rotating section, if the bearing and the shaft are relieved, the bearing will be adjusted; if the bearing wear is impeded, the bearing will be replaced.
2. There is also noise during the pulverization. The cooling sleeve can be used to reduce the temperature, which can allocate water in the crushing chamber.
3. Install a muffler on the fireplace of the crushing room.
4. Resistance equipment, such as using damping boards.
Finally, our classifier can meet customer needs.
Product particle size: D50: 16.7
