Steam Jet Mill for Polymer Powder can be said to be important in the current stage of industrial production, AlPA has been committed to the development and application of equipment such as grading machines for many years, and we produced during the development process of many years. The classifier has gradually begun to develop in the direction of modernization, and we believe that we can provide a complete set of production planning programs in a large range.
The main application of Steam Jet Mill for Polymer Powder determines its extensive application range and finished product. Typical materials are: super hard diamond, silicon carbide, metal powder, etc. High purity requirements: ceramic color, medicine, biochemistry, etc., low temperature requirements: medicine, PVC. By changing the normal air of the gas source into an inert gas such as nitrogen and carbon dioxide gas, it can be used as an inert gas protection device. Suitable for crushing grading treatment of flammable explosive and oxidative materials.
The following describes how the Steam Jet Mill for Polymer Powder device is:
L, the hierarchical device uses the attachment of the jet to effectively combine the inertial force, centrifugal force, and suspension force to design into one Novel ultrafine powder jet classifier. The grading machine reaches high precision, and can be graded, medium and fine powder three levels of products.
2, the jet classifier does not have any moving parts, and only high pressure air is working medium. Reliability for the classifier host, maintenance and maintenance is convenient. The adjustment of grading granularity is also very convenient, and only the flow meter and several gate valves disposed on the machine can be convenient to adjust the grading particle size.
Ultraflight Steam Jet Mill for Polymer Powder is an ultra-microclinated device that uses air separation, heavy polishing, and shear. It is widely used in various industries. Let's take a brief introduction to its daily maintenance content.
1, when the bearing oil is high, it is necessary to stop checking the cause of the fault and removal immediately.
2, easy to wear parts should pay attention to the degree of wear, pay attention to and do the preparation for replacement of parts.
3, for the top surface of the chassis of the active device, it is necessary to remove dust and other debris avoiding the machine that cannot be broken, the active bearing cannot move on the chassis, causing an accident.
4, all loads of the machine are bearings, so good lubrication and bearings have a large relationship, it can directly affect the service life of the machine and the operating rate, so the amount of lubricating oil required to be injected should be reached. Good seal.
5, the sleeper installed is easy to loosen, and it must be checked frequently.
6. Note that the operation of each part of the machine is not normalof.
7. If the rotating gear is in operation, if there is a hitting sound, it should be stopped in time and remove the fault.
Technical parameters:
finished particle size: D90: 800 目
Production capacity: 800-1000kg
