We all know that Spiral Jet Crusher of Carbon is a very strong airflow crushing equipment. Many stubborn hard materials have been cut into a uniform block,
The difference between the pulverizer and ordinary pulverizer in the pulverization:
The ordinary pulverizer can only be smashed into 200 mesh, and 200 mesh is 75 microns. It is the size of the flour, and the ordinary flour is about 80 mesh 160 mes, that is, 90 to 180 microns, this is the thickness of the ordinary pulverizer to print powder.
The ultrafine pulverizer can be super micro-pulverized, can be smashed to 10,000 mesh, 10,000 mesh is 1.3μm, which is equivalent to the particles of the flour, and then pulverized into 70 copies, each size is 10,000 mesh, can It is very thin.
Spiral Jet Crusher's Of Carbon Operation Performance: In the cyclone dust collector, the bag type dust collector is auxiliary, the host is set in the centrifugal grading device, which can be fine grind, and has a classification function, and the wind is cut. No siu or mesh, powder particles can be adjusted arbitrarily, broken materials, negative pressure delivery to exhaust valve ports, reach the product requirements, super fine classifier is widely used in chemical, dyes, coatings, pharmaceuticals, foods, etc. industry.
For the long-term \"health\" of the equipment, we need to take some steps to protect them again. 1. First, the gap of the hammer screen can be adjusted: the friction on the screen changes varies from the distance between the material and the screen, and the friction is different. Improve the hammer speed and hammer material efficiency by adjusting the hammer net gap. However, during the production process, the screens they use are different, the raw materials are different, the hammer screening gap needs to be adjusted; in the crusher, the crusher is not very good at the beginning, but after a period of time Work, the particles inside the crusher also changes; in the grinding machine parts, the hammer head is easily worn, and the gap between the hammer head and the screen is increased, and the yield is also declining, it is difficult to maintain.
Of course, in order to test the yield of a crusher, for some of the raw materials, for some screen holes, in order to determine the appropriate hammer sieve gap and suction, the useful life of the screen and the hammer can be obtained in a short time. Very high grinding efficiency data. However, in the production of feed grinding, such specific measurement data, according to the operator's work experience, the technical content of the crusher itself is two things. People with enrichment of experience and labor experience also require higher operating costs. When the hammer is worn, the gap between the hammer and the sieve increases, the friction is reduced, and the abrasive efficiency is lowered.
2.Spiral Jet Crusher of Carbon mainly requires a reasonable use of reverse glitch: mainly to rush the side hair of the screen into the inside, greatly increase the frictionBut this method is not used for long. After the globi polishing, the efficiency is lowered. It lasts for 30 minutes to 1 hour. .
The friction plate 3 into the Spiral Jet crusher of Carbon: effect of friction lining material having a ring, but with limited effect. First, the teeth of the friction plate are in front of the hammer head, the friction surface is small, and the hammer is long-lasting; if the sieve area is too small, the output screen area will be reduced.
As with any device, in the usual routine maintenance should be carried out before they can ensure the long-term operation of equipment, so routine maintenance is essential for the Spiral Jet crusher of Carbon.
Technical parameters:
Finished size: 10-45μm
production capacity: 300KG
