The equipment in daily use will always cause problems, such as damage caused by operation errors or other reasons. After the fluidized bed pulverizer compresses, after filtration, after drying, the fluidized ultrasonic air flow is introduced through the nozzle, so that the material is fluidized, and the accelerated material is integrated in several nozzles. The collision, friction, and cut the microcarriers of the particles. After the pulverized material is conveyed into the impeller grading area, under the action of the graded wheel effort and fan effort, the coarse powder is separated, and the coarse powder returns to the crushing chamber according to its own gravity, and the qualified fine powder is Airflow enters the cyclone, fine dust is collected by the bag dust collector, and the purified gas is discharged from the air. Air flow milling is compressed by the Raval nozzle accelerates the supersonic gas stream, and the injection zone is brought into the pulverization region to cause the material to be fluidized (the airflow expansion is suspended, and therefore, each particle has the same motion state). . At this time, we need maintenance personnel to repair, but this maintenance cost is very expensive. Sometimes repair workers, because he is too troublesome, replacing some fault equipment for the fluidized bed crusher. Although this is indeed a small problem, if this is a method of solving the problem, what should I do if I don't buy new equipment or parts directly, so we must understand the installation and maintenance of the equipment used. This way we can easily find the problem. The reason for finding a problem.
So important is the usage specification. In daily operations, we must install normal operations to use the equipment, we must constantly check the temperature of the equipment. When the temperature exceeds 50 degrees, the reason for shutting down the fluidized bed pulverizer is an important part of the belt is a mill operation, so it is necessary to adjust the belt. Some auxiliary vanes and other parts need to be replaced after wear to avoid particle size.
