Of course, it is not necessarily a machine noise. Mechanical noise is sometimes a normal phenomenon, generally at 75 decibels, due to noise, if noise is very large, starting from machine operation time, stopping the noise, the main reason for Jet Mill is The noise during the damage is caused by the unstable components formed by the loose screw, followed by too little material or excessive failure, so it can be rechargeable.
Air Flow Working is compressed air to accelerate the zavall nozzle to accelerate the ultrasonic speed airflow into the pulverized zone to make the material are fluidized (the airflow expansion is suspended to each other. " Collision), so each particles have the same motion state. If the above problem is not processed, the internal hammer check the screw element can be opened on the machine.
When using grinding, for novices, in the operation, a pluging phenomenon often occurs, the motor rotates, producing a harsh sound. Jet Mill makes a complete set of crushing systems. After the compressed air is dried, it is sprayed into the pulverizing chamber by the Lavar nozzle, and the material is repeatedly collided with the intersection of the multi-high pressure airflow. The crushing material is pulverized after the fan pulling force Airflow movement to the grading area, under the power of high-speed rotation, the thick centrifugal force generated by the high-speed rotation, the fine particles that meet the particle size requirements are collected by the grading wheel into the cyclone and the dust collector, and the crude particles drops to the pulverizing region to continue pulverization. . The cluster blockage is a common fault, nor does it need to panic, master basic knowledge can be easily resolved.
Generally, the main reason is that when the airflow mill feed is too fast, the motor speed is not kept up, and Jet Mill material is transported according to the machining efficiency of the machine; the other reason is the blade or tool damage Serious, also makes the airflow mills do not work properly.
