How to block what to do during use during use?
The following is a brief introduction by one of the shredder manufacturers. Crusher blocking is one of the common faults in the use of crusher, may have problems in the design, but more due to improper use of operations.
(1) The feed speed is too fast, the load is increased, resulting in blockage. During the feed, pay attention to the current table pointer deflection angle, if the rated current is exceeded, indicating that the motor is overloaded, and the motor will be burn down the motor. This situation should be reduced or closed immediately, or the feed is changed, and the feed amount is controlled by increasing the feeder. The feeder has manual, automatic, and the user should select the appropriate feeder according to the actual situation. Due to the high speed of the pulverizer, the load is large, and the fluctuation of the load is strong. Therefore, the current at work at the time of milling is generally controlled around 85% of the rated current.
(2) If the discharge pipe is not smooth or the feed is too fast, the crushing machine is blocked; if it matches the delivery device, it will cause the discharge pipe to reduce or block the air. After the failure, you should first clear the delivery device that does not match the delivery, adjust the amount of feed, so that the equipment is operating normally.
(3) The hammer pieces, aging, screen hole are closed, tattered, and smashing materials are too high, and the crusher will block the crusher.
The broken and severe aging hammers should be updated regularly, keep the crusher's good working condition, and regularly check the screen, the water content of the powder should be less than 14%, so it can improve production efficiency, but also make the pulverizer do not block, Enhance the reliability of the milling machine.
The above is a crusher manufacturer, how to put it out how the crusher is blocked during use, more about crusher consulting, please continue to pay attention to the ALPA powder official website!
