Now talk about Jet Mill security operations, here, Jet Mill security operations.
Jet Mill's knowledge is much, which is the point of this today?
To this end, Xiaobian is looking at the contents of the previous article, and it has not yet introduced its safety operation procedures.
Therefore, we will introduce this opportunity today, so that everyone can master it earlier, and can apply it. In practice.
1. Jet Mill Preparation
(1) Check all the lines and electrical components, whether it is normal, and is well grounded.
(2) The spindle has a card-free death, whether there is a debris or slide in the studio, if it should be handled or cleaned up in time. After everything is not a problem, you can press the start button. Wait until the machine is running smoothly before it can start the feed.
2. Operation and precautions
(1) The feed should be uniform, not excessive, and the speed is too fast to avoid blocking the machine, or cause the motor overload to damage the motor.
(2) At any time in Jet Mill, you should pay attention to the operation of the machine, if you have an abnormality, stop checking immediately.
(3) General Jet Mill does not work for 24 hours to avoid excessive temperature of the machine.
(4) Jet Mill runs, you cannot clean, overhaul, etc.
(5) Before the Jet Mill stops, stop the feed first. When the machine stops running, the waste inside and outside the machine is cleared.
(6) When the crusher is parked, it cannot be loaded.
