At the same time, while using Jet Mill, it is often only focused on the use of the product, and there is not much detail.
Sometimes users understand very little knowledge about Jet Mill, so there will be some in operation. Small problems, making Jet Mill can't play the biggest effect during use, and then the small series will introduce the maintenance of its life.
1. During the production process, the temperature rise of the bearings must be often checked. When the temperature rise exceeds 50 ° C, it should be closed, and the reason is to rule out the fault.
2, when the new machine is running, the drive belt is easy to elongate, and should pay attention to adjust the appropriate looseness of the belt to ensure the work life of the belt.
3. If the loss case should be checked frequently, replace the quality and production volume in time.
4, blade, the bushing should often check the wear situation, if wear, the productivity decreases, and the particle size is replaced after the particle size is replaced.
5, the host and the grading flow bearing are lipid lubrication, using 2 special lipids, degrees 265-295.
6, and the bearing changes period of 2000 hours, the amount of the filling of the grease is 1/2 of the space in the bearing cavity (upper Measurement) or 3/4 (lower test) Do not fill the grease too much or if the bearing temperature is too high.
7, the spiral feeder has changed the lipid period of 4,000 hours, and the calcium-based grease is added.
Welcome to Shandong Alpa Powder Technology Co., Ltd., above the Jet Mill life extension method.
