High-speed Jet Mill, it is a crushing equipment. For us, it is also an object of our study, so let's take a simple introduction and explanation of this crusher, I hope to let Everyone can understand other types of crushers while understanding Jet Mill. SF-300 high speed crusher, mainly for pharmaceutical, food, chemical, scientific research, metallurgical and other industries, is very wide, suitable for chemical materials, Chinese herbal medicines, etc., the dried and brittle materials such as Chinese herbal medicines.
1. Structural features (1) low operating noise, high production efficiency, and smooth running. (2) The material after pulverization can be discharged directly at the abdomen of the machine, and the pulverized particle size diameter of the particles can be adjusted by adjusting the aperture screen.
2. Debugging Once the machine is in place, it should be placed smoothly. Before you test the machine, you should clean the machine first. After the power is turned on, you should pay attention to whether the direction of rotation of the spindle is correct. When testing, pay attention to whether the machine has an abnormal phenomenon, if there is a timely parking check.
3. Maintenance
(1) It is necessary to place smoothly to avoid vibration.
(2) Whether the rotation of the spindle is correct, and the correction is performed.
(3) Before the material starts crushing, first allow the machine to run for 30 seconds, and there is no abnormality before the material is smashed.
(4) The amount of input of materials cannot be too large. After the material is pulverized, it should be cleaned to the pulverization room so as to ensure the purity of the material.
(5) Frequently check the lubrication, the color of the lubricating oil is black, and should be cleaned and replaced immediately because it has become metastasis.
The above is some basic knowledge of the crusher, hoping to make everyone a probably aware of this crusher. The compressed air is accelerated from a fluidized bed, and the fluidized bed is accelerated, and the pulverizing cavity is formed in the fluidized bed pulverizer. The material is entered into the fluidized bed pulverizer by the fding outlet.
Under the driving flow, the material is collided with each other in the middle of the pulverized cavity and pulverized. The qualified fine powder is carried by the rising gas stream into the turbo grace machine enters the upper portion of the fluidized bed, and the classifier is graded after grading the qualified material into the cyclone collector. The finer tail portion is carried from the airflow into the bag dust collector. After filtration of the bag, the tail is removedThe droplet of the lower part of the dust is covered with pure air.
The airflow is pulverized, the host does not have any moving parts, and there is no motor such as a motor. The high-pressure air generated by the air compressor is released in an instantone of the airflow nozzle of the pulverizer to the interior of the crushing host, and there is no traditional "mill ring" inside the main unit, "grinding" The pulverized medium such as the ball "," wear rail "is in contact with material, and the material is driven by high pressure air, and the interior of the pulverized host is collided with each other to achieve the purpose of pulverization.
The entire pulverization process has no traditional long-term pressure and friction. The material is smashed by the mutual collision force. The pulverization process is not contacted with the equipment material, suitable for high hard, high purity, thermal material, and there is no traditional equipment wear. Question.
