Upper machine equipment, it is generally a matching device of the pulverizer, especially Jet Mill, so when using a crusher, sometimes the automatic feeder is essential, that is, mentioned, below, we will add this feeding machine Let's take a brief introduction, I hope everyone can understand and understand it.
First, the working principle of the automatic feeder closes the vacuum tube, then activates the motor, uses a low vacuum stream, and then feed the plastic resin particles into the vacuum tube.
Wait until the motor stops rotation, then discharge the particles into the hopper, this will cycle.
Second, the operation procedure for automatic feeder
1. Pre-working
(1) wire rope, the pulley is intact, whether the wear is severe, whether it is broken, broken shares, if you should repair or replace it.
(2) Attach the air transition truck, pay attention to the operation of the various parts, whether the cartridge cart movement meets the requirements.
(3) Everything is confirmed that it can begin to add it.
2. Work
(1) The bucket should be aligned, so that the quantitative fight can be started.
(2) If the electrical signal is confusing, it should be done to check and resolve.
(4) The material of the bucket cannot be too much, no matter where the bucket trolley, the wire rope must be tightened and cannot be relaxed.
3. After working
(1) The cartrust car should stop in the lower limit position.
(2) Clean up and organize the job site and clean the health.
Welcome to Shandong AlPa Powder Technology Co., Ltd., where there is a vacuum machine device.
